1.安装openssh-server
打开终端安装openssh-server软件包:
sudo apt update
sudo apt install openssh-server
2.查看ssh状态
安装完成后,ssh服务默认启动了,可以通过下面的命令检查服务运行状态:
sudo systemctl status ssh
如果出现以下的内容,注意“active”是“running”,说明ssh服务启动了。
ssh.service - OpenBSD Secure Shell server Loaded: loaded (/lib/systemd/system/ssh.service; enabled; vendor preset: enabled) Active: active (running) since Mon 2022-07-13 09:14:00 CEST; 10s ago ...
3.防火墙开启ssh端口
Ubuntu 默认使用 ufw 防火墙配置工具,如果启用了防火墙,需要让防火墙开启ssh端口:
sudo ufw allow ssh
4.配置允许root远程ssh登录访问
使用sudo权限,编辑ssh的配置文件。
sudo vim /etc/ssh/sshd_config
将#PermitRootLogin prohibit-password
中prohibit-password
去掉改为yes
,并把PermitRootLogin yes
之前的#
去掉,即
PermitRootLogin yes
重启ssh服务
service sshd restart
4.连接ssh服务
通过网络连接到 Ubuntu 计算机,请使用以下格式调用 ssh 命令,然后输入用户名和IP地址:
ssh username@ip_address
首次连接时会看到以下内容(192.168.1.102是需要被ssh远程访问的IP地址,是内网IP地址)
The authenticity of host '192.168.1.102 (192.168.1.102)' can't be established. ECDSA key fingerprint is SHA256:AqAuoVjwoRuoiFCZ6tdDmIZBvixrHZn4ykzHkB+wVb8. Are you sure you want to continue connecting (yes/no/[fingerprint])?
输入yes后按回车键,提示输入密码。
Warning: Permanently added '192.168.1.102' (ECDSA) to the list of known hosts. linux265@192.168.1.102's password:
正确输入密码后,连接建立。
5.ssh服务的启用与禁用
sudo systemctl disable --now ssh
sudo systemctl enable --now ssh
本文内容由网友自发贡献,版权归原作者所有,本站不承担相应法律责任。如您发现有涉嫌抄袭侵权的内容,请联系:hwhale#tublm.com(使用前将#替换为@)